Data integration with Solidworks via Direct PLM Connector

Hello everyone,

recently we have started a project with ARAS PLM. Our 3D drawings are done in Solidworks. For integration with ARAS we use DirectPLM connector. During the process we have noticed that saving an assembly into ARAS takes hours - main assembly crashed after 7hours. Has someone experienced the same or this is not normal and there should be somewhere connector configuration error?

Thank you in advance,

Arvydas Barysas

Top Replies

Offline Abarysas Vor über 4 Jahren in reply to Yellowpillow +1

Well, after couple of unsuccessful attempts we involved Direct PLM vendor Focus PLM company and they cleaned the data and repeated the load process. It was not extremely fast, however, exercise was completed…

Offline Yellowpillow Vor über 4 Jahren

We have the same problem with the Direct PLM connector. We use Artec software -> Solidworks -> ARAS and saving the assemblies take a few hours usually with frequent crashes. Have you found the solution to this problem? If so, could you share it?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Offline Abarysas Vor über 4 Jahren in reply to Yellowpillow

Well, after couple of unsuccessful attempts we involved Direct PLM vendor Focus PLM company and they cleaned the data and repeated the load process. It was not extremely fast, however, exercise was completed without crashes. So, my guess crashes happening due to incorrect drawings structure in Solidworks.
Cancel
Vote Up +1 Vote Down

Sign in to reply

Cancel
Offline Yellowpillow Vor über 4 Jahren in reply to Abarysas

Thank you for the fast reply, we will check our drawings again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Offline xin.yuan Vor 10 Monaten in reply to Yellowpillow

hello, How to use PLM connector to integrate with Solidworks, Thanks a lot.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Data integration with Solidworks via Direct PLM Connector

Top Replies

Legal

Connect With Us